RADVision Scopia XT1000 Administrator's Manual - page 64
'Maintenance Tasks' | 58
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Note:
You may always downgrade the system to a previous version. Call customer support for help.
Procedure
Step 1
Verify that the Codec Unit is switched on, and is connected to the IP network interface. (The
network cable must be connected to the GLAN connector, marked 10/100/1000, on the back
panel of the Codec Unit.)
Step 2
Verify that the network allows communication between the Codec Unit and the PC, and that a
firewall does not block TCP port 55099.
Step 3
In the terminal GUI navigate to Admin Settings > Utilities > Remote Access > Download. Verify
that Download management is set to Yes, and that the IP address of the PC where the
Landownload program is going to be executed is included among the enabled IP addresses.
Figure 3-3
Enabling Download Management
Step 4
Access the RADVISION site as explained at the beginning of this section, or contact Customer
Support.
Step 5
Download the XT1000_Vxxx.exe from the RADVISION site to a Windows PC.
Step 6
In the PC double click the XT1000_Vxxx.exe. It will auto extract the Landownload program.
Step 7
Enter the IP address of the Codec Unit in the start screen and select the Start button.
Figure 3-4
Landownload Start Screen
The download of the software will begin and the Codec Unit GUI will be updated with the progress
status.
CAUTION: After download begins do not shut down the Codec Unit until download is completed.
At the end of the update, the Codec Unit will reboot automatically.