RADVision Scopia XT1000 Administrator's Manual - page 66
'Maintenance Tasks' | 60
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 4
Set the fields as required.
Note:
To configure the network, contact your network administrator.
Step 5
Press
Save.
Configuring the System for SNMP Management
iVIEW/NMS integration allows remote monitoring, configuring, upgrading and control features of
SCOPIA XT1000 terminals, using SNMP (Simple Network Management Protocol) and an AT
command-based protocol on TCP/IP. In particular, these features have been introduced:
•
Monitoring - iVIEW/NMS can request identification and access capabilities from the terminal.
•
Status traps - iVIEW/NMS is able to detect if the terminal is turned on, and its call status.
Procedure
Step 1
In the Administrator settings menu scroll to Utilities.
Step 2
Select Remote access.
Step 3
Select the SNMP page.
Field Name
Description
AT commands management Enables/disables AT Command API for remote control.
Enable all addresses
If set to Yes, enables access to the Codec Unit from any IP address
in a network. If set to No, configure Address and SubNet mask.
Address
Enter the IP address allowed to access the system.
SubNet mask
Enter the SubNet mask associated with the IP address.