D-Link DWL-2600AP User Manual - Erase Startup-Config File
Erase Startup-config File
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 179
D-Link UWS User Manual
Erase Startup-config File
Use the Erase Startup-config File to erase the startup-configuration file.
To display this page, click
Tool > Erase Startup-config File
in the navigation menu.
Figure 91: Erase Startup-config File
AutoInstall
The AutoInstall feature enables the configuration of a switch automatically when the device is turned on and,
during the boot process, no configuration file is found in device storage. By communicating with a DHCP
server, AutoInstall obtains an IP address for the switch and an IP address for a TFTP server. AutoInstall
attempts to download a configuration file from the TFTP server and install is on the switch.
After obtaining IP addresses for both the switch and the TFTP server, the AutoInstall feature attempts to
download a host-specific configuration file using the boot file name specified by the DHCP server. If the switch
fails to obtain the file, it will retry indefinitely.
To display this page, click
Tool > AutoInstall
in the navigation menu.
Figure 92: AutoInstall