D-Link DWL-2600AP User Manual - Valid Access Point Summary

Basic Setup

D-Link

Unified Wired and Wireless Access System 

Oct. 2015

Page 569

D-Link UWS User Manual

Valid Access Point Summary

The Wireless Global Configuration page contains a field to select whether to use a local or RADIUS database 

for AP Validation. The 

Valid Access Point Summary

 page contains information about APs configured in the 

local database. If the AP Validation is set to RADIUS, information about the APs to be managed by the switch 

must be added to the external RADIUS database.

You can add an AP into the local list of Valid APs from the 

WLAN > Administration > Basic Setup > Valid AP

tab, as the following figure shows, or you can add an AP from the AP Authentication Failures or Rogue

 AP/RF 

Scan lists. 

Figure 365:  Adding a Valid AP

Table 333:  Valid Access Point Summary

Field

Description

AP Database

Identifies the total number of APs that have been added to the AP database. 

Managed AP

Identifies the number of APs in the database with an AP Mode set to Managed.

Rogue AP

Identifies the number of APs in the database with an AP Mode set to Rogue.

Standalone AP

Identifies the number of APs in the database with an AP Mode set to Standalone.

MAC Address

Enter the MAC address of the AP in this field. When you add the MAC address, you 

add the AP to the local database on the switch.

Location

Enter a location to help identify the AP. This field is optional and accepts up to 32 

alphanumeric characters, including special characters.

AP Mode

This field displays the current mode of the AP, which can be one of the following:

• Managed

• Standalone

• Rogue

To configure a different mode, click the MAC address of the AP to go to the Valid 

Access Point Configuration page.