D-Link DWL-2600AP User Manual - page 205
Configuring GARP
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 205
D-Link UWS User Manual
The GARP Status page contains the following fields:
Table 98: GARP Status Fields
Field
Description
Switch GVRP
Shows whether the switch GVRP protocol is enabled or disabled.
Switch GMRP
Shows whether the switch GMRP protocol is enabled or disabled.
Slot/Port
Identifies the system interface.
Port GVRP Mode
Shows the GARP VLAN Registration Protocol administrative mode for the port.
If the mode is Disabled, the protocol will not be active and the Join Time, Leave
Time and Leave All Time will have no effect.
Port GMRP Mode
Shows the GARP Multicast Registration Protocol administrative mode for the
port. If the mode is Disabled, the protocol will not be active, and Join Time,
Leave Time and Leave All Time have no effect.
Join Timer (centisecs)
Shows the time between the transmission of GARP PDUs registering (or re-
registering) membership for a VLAN or multicast group in centiseconds.
Leave Timer (centisecs)
Displays time lapse, in centiseconds, that the switch waits before leaving its
GARP state. Leave time is activated by a Leave All Time message sent/received,
and cancelled by the Join message received.This allows time for another station
to assert registration for the same attribute in order to maintain uninterrupted
service.
Leave All Timer (centisecs)
Displays time lapse, in centiseconds, that all switches wait before leaving the
GARP state. The leave all time must be greater than the leave time
.
The Leave
All Time controls how frequently LeaveAll PDUs are generated. A LeaveAll PDU
indicates that all registrations will shortly be deregistered. Participants will
need to rejoin in order to maintain registration.