D-Link DWL-2600AP User Manual - Router
Router
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 314
D-Link UWS User Manual
• Click
Refresh
to update the information on the screen.
Router
The pages accessible from the
Router
folder allow you to configure the routing table and configure route
preferences.
Route Table
The route table manager collects routes from multiple sources: static routes, RIP routes, and local routes. The
route table manager may learn multiple routes to the same destination from multiple sources. The route table
lists all routes. The best routes table displays only the most preferred route to each destination (see
for more information).
To display the page, click
LAN > Monitoring > L3 Status > Route Table
in the navigation tree.
Figure 202: Route Table
Minimum Advertise
Interval(secs)
The minimum time (in seconds) allowed between router advertisements
sent from the interface.
Advertise Lifetime(secs)
The value (in seconds) used as the lifetime field in router advertisements
sent from the interface. This is the maximum length of time that the
advertised addresses are to be considered as valid router addresses by hosts.
Preference Level
The preference level of the router as a default router relative to other
routers on the same subnet. Higher numbered addresses are preferred.
Table 184: Route Table Fields
Field
Description
Total Number of Routes
The total number of routes in the route table.
Network Address
The IP route prefix for the destination.
Subnet Mask
Also referred to as the subnet/network mask, this indicates the portion of the
IP interface address that identifies the attached network.
Table 183: Router Discovery Status Fields (Cont.)
Field
Description