D-Link DWL-2600AP User Manual - Rip Interface Summary
Configuring RIP
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 308
D-Link UWS User Manual
RIP Interface Summary
Use the RIP Interface Summary page to display RIP configuration status on an interface.
To display the page, click
LAN > Monitoring > L3 Status > RIP > Interface Summary
in the navigation tree.
Figure 197: RIP Interface Summary
• Click
Refresh
to update the information on the screen.
Table 179: RIP Interface Summary Fields
Field
Description
Interface
The interface, such as the routing-enabled VLAN on which RIP is enabled.
IP Address
The IP Address of the router interface.
Send Version
Specifies the RIP version to which RIP control packets sent from the interface
conform. The default is RIP-2. Possible values are:
•
RIP-1:
RIP version 1 packets are sent using broadcast.
•
RIP-1c:
RIP version 1 compatibility mode. RIP version 2 formatted packets
are transmitted using broadcast.
•
RIP-2:
RIP version 2 packets are sent using multicast.
•
None:
RIP control packets are not transmitted.
Receive Version
Specifies which RIP version control packets are accepted by the interface. The
default is Both. Possible values are:
•
RIP-1:
only RIP version 1 formatted packets are received.
•
RIP-2:
only RIP version 2 formatted packets are received.
•
Both:
packets are received in either format.
•
None:
no RIP control packets are received.
RIP Admin Mode
Specifies whether RIP is Enabled or Disabled on the interface.
Link State
Specifies whether the RIP interface is up or down.