D-Link DWL-2600AP User Manual - Acl Interface Configuration

ACL Interface Configuration

D-Link

Unified Wired and Wireless Access System 

Oct. 2015

Page 371

D-Link UWS User Manual

ACL Interface Configuration

When an ACL is bound to an interface, all the rules that have been defined are applied to the selected 

interface. Use the ACL Interface Configuration page to assign ACLs and Interfaces and prioritize the ACLs that 

are bound to each interface. To display the ACL Interface Configuration page, click 

LAN > QoS > Access Control 

Lists > Interface Configuration

 in the navigation menu.

Figure 250:  ACL Interface Configuration

If an ACL has been assigned to the interface, it displays in the table at the bottom of the page.

Table 216:  ACL Interface Configuration Fields

Field

Description

Interface

Select the interface or LAG from the menu. 

Direction

Specifies the packet filtering direction for the ACL. The system supports 

Inbound filtering. inbound filtering means the system applies the ACL rules to 

packets as they enter the interface.

ACL Type

Use the menu to select the ACL type to which incoming packets are matched. 

Packets can be matched to IP- or MAC-based ACLs. 

IP/MAC ACL

Select the ACL of the specified type to apply to the interface from the 

dropdown menu.

Sequence Number

Assigns the priority of this ACL. If more than one ACL is applied to an interface, 

then the match criteria for the highest sequence ACLs are checked first. A 

lower number indicates higher priority. If a sequence number is already in use 

for this interface and direction, the specified access list replaces the currently 

attached access list using that sequence number. If you do not specify a 

sequence number, a sequence number that is one greater than the highest 

sequence number currently in use for this interface and direction is used. The 

valid range is 1-4294967295.