D-Link DWL-2600AP User Manual - Managed Ap Advanced Settings
AP Management
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 586
D-Link UWS User Manual
Managed AP Advanced Settings
When the AP is in Managed mode, remote access to the AP is disabled. However, you can enable Telnet access
by enabling the Debug feature on the
AP Management > Advanced Settings
page. From the
Managed AP
Advanced Settings
page, you can also manually change the RF channel and power for each radio on an AP. The
manual power and channel changes override the settings configured in the AP profile (including automatic
channel selection) and take effect immediately. The manual channel and power assignments are not retained
when the AP is reset or if the profile is reapplied to the AP, such as when the AP disassociates and reassociates
with the switch.
Figure 374: Advanced
AP Management
Each AP managed by the DWS-4000 Series switch is listed by its MAC address and location. The location is
based on the value in the RADIUS or local Valid AP database.
describes the Advanced features you
can configure for the AP.
Table 343: Advanced AP Management
Field
Description
MAC Address
Shows the MAC address of the AP.
Location
Shows the AP location, which is based on the value configured in the RADIUS or local
Valid AP database.
Debug
To help you troubleshoot, you can enable Telnet access to the AP so that you can
debug the device from the CLI.
The Debug field shows the debug status and can be one of the following:
• Disabled
• Set Requested
• Set in Progress
• Enabled
To change the status, click the
Debug
status link. The Managed AP Debug page
appears.
describes the fields on the new page.
Radio
Identifies the radio to which the channel and power settings apply.
Channel
Click the
Channel
link to access the Managed AP Channel/Power Adjust page. From
that page, you can set a new channel for Radio 1 or Radio 2. The available channels
depend on the radio mode and country in which the APs operate. The manual
channel change overrides the channel configured in the AP profile and is not retained
when the AP reboots or when the AP profile is reapplied.
describes the fields on the new page.