D-Link DWL-2600AP User Manual - Boot Menu Functions
Booting the Switch
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 49
D-Link UWS User Manual
For information about the Boot menu, see “
." If you do not start the boot
menu, the operational code continues to load.After the switch boots successfully, the User login prompt
appears and you can use the local terminal to begin configuring the switch. However, before configuring the
switch, make sure that the software version installed on the switch is the latest version. If it is not the latest
version, download and install the latest version. See
“Download File To Switch (TFTP)” on page 171
Boot Menu Functions
You can perform many configuration tasks through the Boot menu, which can be invoked after the first part
of the POST is completed.
Use the following procedures to display the Boot menu:
1.
During the boot process, press
2
within ten seconds after the following message displays:
Boot Menu Version: 12 jun 2007
Select an option. If no selection in 10 seconds then
operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
Boot Menu Version: 12 jun 2007
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM
4 - Load new operational code using XMODEM
5 - Load configuration using XMODEM
6 - Display operational code vital product data
7 - Run flash diagnostics
8 - Update boot code
9 - Delete operational code
10 - Reset the system
11 - Restore configuration to factory defaults (delete config files)
12 - Activate Backup Image
[Boot Menu]
The following sections describe the Boot menu options. If no selection is made within 10
seconds
(default),
the
operational code starts.