D-Link DWL-2600AP User Manual - page 556

Basic Setup

D-Link

Unified Wired and Wireless Access System 

Oct. 2015

Page 556

D-Link UWS User Manual

The following table describes the fields on the 

SSID

 page.

Command Buttons

The page includes the following buttons:

•

Refresh

—Updates the page with the latest information.

•

Submit

—Updates the switch with the values you enter. To retain the new values across a power cycle, 

you must perform a save on the WLAN switch (not the AP). To perform a save, click Tool > Save Changes.

•

Next

—Navigates to the next page in the Basic Setup configuration. Any changes you made to the current 

page are saved before the next page is displayed. To retain the new values across a power cycle, you must 

perform a save on the WLAN switch (not the AP). To perform a save, click Tool > Save Changes.

Table 329:  Default VAP Configuration

Field

Description

Radio 1

Radio 2

You configure the VAPs for Radio 1 and Radio 2 separately. Select the radio to configure 

the settings for before you enable the VAP.

The DWL-3600AP is a single-radio AP. Any settings you configure for Radio 1 (802.11a/n) 

are not applied to the DWL-3600AP. If the selected Hardware Type ID for the AP profile is 

DWL-3600AP, the radio selectors are not available.

Network

Use the option to the left of the network to enable or disable the corresponding VAP on 

the selected radio.

When enabled, use the menu to select a networks to assign to the VAP. You can configure 

up to 64 separate networks on the switch and apply them across multiple radio and VAP 

interfaces. By default, 16 networks are pre-configured and applied in order to the VAPs on 

each radio. 

Enabling a VAP on one radio does not automatically enable it on the other radio.

Note: 

You cannot disable the default VAP, VAP0.

Note: 

The IEEE 802.11n standard prohibits static WEP and dynamic WEP (IEEE802.1X) 

security modes. Additionally, 802.11n requires the CCMP(AES) WPA cypher to be enabled. 

If the AP profile includes the 802.11n radio mode, you cannot select a configured network 

from the 

Network

 menu if the network uses static or dynamic WEP as the security method 

or if the CCMP(AES) WPA cypher is not enabled.

To configure additional networks, click 

WLAN > Administration > Advanced Configuration 

> Networks

.

Edit

Click 

Edit

 to modify settings for the corresponding network. 

When you click 

Edit

, the Wireless Network Configuration page appears.

VLAN

Shows the VLAN ID of the VAP. To change this setting, click 

Edit

.

L3 Tunnel

Shows whether L3 Tunneling is enabled on the VAP. To change this setting, click Edit.

Note: 

When L3 tunneling is enabled, the VLAN ID is not used. In fact, the switch puts the 

management VLAN ID, if any, on the tunneled packets.

Hide SSID

Shows whether the VAP broadcasts the SSID. If enabled, the SSID for this network is not 

included in AP beacons. To change this setting, click 

Edit

.

Security

Shows the current security settings for the VAP. To change this setting, click 

Edit

.

Redirect

Shows whether HTTP redirect is enabled. The possible values for the field are as follows:

• HTTP: HTTP Redirect is enabled

• None: HTTP Redirect is disabled