D-Link DWL-2600AP User Manual - Ap Provisioning
AP Management
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 590
D-Link UWS User Manual
AP Provisioning
The AP Provisioning feature helps you add new APs to an existing switch cluster. With AP Provisioning, you can
configure the access points with parameters that are needed to connect to the wireless network.
Use AP Provisioning to connect devices to a network enabled for mutual authentication. If a network is not
enabled for mutual authentication then APs can be attached to the network by properly configuring the local
Valid AP database or RADIUS AP database and discovery options. The provisioning feature can optionally be
used on networks not enabled for mutual authentication to simplify AP attachment to the cluster.
AP Provisioning Summary Status
Use the
AP Provisioning Summary Status
page to view information about all provisioned APs.
Figure 377: AP Provisioning Summary Status
The following table shows the fields available on the
AP Provisioning Summary Status
page.
Note:
The AP Provisioning Summary and Detail pages display data only when the switch is configured
as the Cluster Controller.
Table 346: AP Provisioning Summary Status
Field
Description
MAC Address
MAC address of the AP
IP Address
IP Address of the AP.
Primary IP Address
The IP address of the primary provisioned switch as reported by the
AP.
Backup IP Address
The IP address of the backup provisioned switch as reported by the AP.
New Primary IP Address
Enter the IP address of primary switch to which the AP should try to
connect.
New Backup IP Address
Enter the IP address of switch to which the AP should try to connect if
it is unable to connect to the primary switch.