D-Link DWL-2600AP User Manual - page 412
RADIUS Settings
D-Link
Unified Wired and Wireless Access System
Oct. 2015
Page 412
D-Link UWS User Manual
Use the buttons at the bottom of the page to perform the following actions:
• Click
Refresh
to update the page with the most current information.
• If you make changes to the page, click
Submit
to apply the changes to the system.
Number of Named Accounting
Server Groups
The number of accounting server groups configured on the system. An
accounting server group contains one or more configured authentication
servers that share the same RADIUS server name.
Max Number of Retransmits
The value of the maximum number of times a request packet is retransmitted.
The valid range is 1-15.
Consideration to maximum delay time should be given when configuring
RADIUS max retransmit and RADIUS timeout. If multiple RADIUS servers are
configured, the max retransmit value on each will be exhausted before the
next server is attempted. A retransmit will not occur until the configured
timeout value on that server has passed without a response from the RADIUS
server. Therefore, the maximum delay in receiving a response from the
RADIUS application equals the sum of (retransmit times timeout) for all
configured servers. If the RADIUS request was generated by a user login
attempt, all user interfaces will be blocked until the RADIUS application
returns a response.
Timeout Duration (secs)
The timeout value, in seconds, for request retransmissions. The valid range is
1 - 30.
See the Max Number of Retransmits field description for more information
about configuring the timeout duration.
Accounting Mode
Use the menu to select whether the RADIUS accounting mode is enabled or
disabled on the current server.
Enable RADIUS Attribute 4
(NAS-IP Address)
To set the network access server (NAS) IP address for the RADIUS server,
select the option and enter the IP address of the NAS in the available field.
The address should be unique to the NAS within the scope of the RADIUS
server. The NAS IP address is only used in Access-Request packets.
NAS-IP Address
Enter the IP address of the NAS. This field can be edited only when the Enable
RADIUS Attribute 4 field is selected.
The address should be unique to the NAS within the scope of the RADIUS
server. The NAS IP address is only used in Access-Request packets.
Accounting Interim Update
Mode
Enable the option to send RADIUS Accounting (Interim-Update) based on
Interim Interval Period. By default this mode is disabled.
Radius Accounting Interim
Interval
This interim Interval at which Radius Accounting (Interim-Update) packets
should be sent by the switch. The value should be in the range 300 - 3600. By
default it is not configured.
Table 242: RADIUS Configuration Fields (Cont.)
Field
Description