Oki ES8453 MFP User Manual - Connecting With A Lan Cable
Connecting with a LAN Cable
If there is no DHCP server on a network, you must set the IP address on a computer or
machine manually.
Even if you are instructed to set a unique IP address that is specified by your network
administrator, Internet service provider, or router manufacturer, you must set the IP
address to the computer and machine manually.
Note
Complete the network setting of the computer before this procedure.
You must log in as the administrator.
If you set an IP address manually, contact your network administrator or Internet service
provider for the IP address to use. If the IP address is set incorrectly, the network may go
down or Internet access may be disabled.
Memo
If you construct a small network that consists of only the machine and a computer, set IP
addresses as shown below (according to RFC1918).
For the computer
IP address: 192.168.0.1 to 254
Subnet mask: 255.255.255.0
Default gateway: Not used
DNS server: Not used
For the machine
IP address setting: Manual
IP address: 192.168.0.1 to 254 (Select a different value from the computer's IP address.)
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0
Network scale: Small
To set [Network Scale], select [Device Settings] > [Admin Setup] > [Network Menu] >
[Network Setup] > [Network Setting] > [Network Scale] > [Small].
1.
Prepare a LAN cable and hub.
Prepare a LAN cable (category 5 or higher, twist pair, straight) and hub.
2.
Turn the machine and computer off.
1106