Oki ES8453 MFP User Manual - page 978
Range: 75,
85, 100
mseconds
Pulse setting is TONE.
Calling Timer
60
mseconds,
Range: 1 -
255 seconds
Displays only if Service Bit is ON.
PBX Line
OFF
When connecting to PBX (internal
exchange), put it to [ON].
Forwarding
Setting
Forwarding Setting
OFF
Sets whether to enable the fax
forwarding mode.
Forwarding Number
(NULL)
Sets a fax number used for the fax
forwarding mode.
TAD Mode
Type 3
Sets an operation type in Tel / Fax
Ready mode.
[Type 3]: A fax signal is detected in
15 seconds from when the
answering machine answers.
Normally, use this type.
[Type 1]: A fax signal is detected
right after the answering machine
answers, and then the reception
starts. If you have any fax
reception problems, they may be
improved if this type is set.
[Type 2]: A fax signal is detected
right after the answering machine
answers. Set this type if you
usually use this machine as a
phone.
Tel Priority Mode
OFF
Sets when the external telephone
and the machine ring in Tel / Fax
Ready mode.
[ON]: The sender is assumed to
make a voice call. The telephone
rings early.
CNG Detection
OFF
Sets whether to determine whether
the sender is sending a fax during
the off the hook condition in Tel /
Fax Ready mode.
T/F Timer Programming
35 seconds
Sets when to start the auto fax
reception if the communication
does not start even after an
incoming call arrives in Tel / Fax
Ready mode or Ans / Fax Ready
mode.
Soft Ringer Volume
High
Sets a phone ring volume in Tel /
Fax Ready mode.
Remote Receive Number
OFF
Sets a remote switch over number.
977