Oki ES8453 MFP User Manual - Setting to Use Remote Scan
If the computer information, such as computer name or IP address is changed, you need
to newly register the information.
Setting to Use Remote Scan
Enable the Network TWAIN function so that you can use the Remote Scan function on a
computer.
Note
If you set this function to [OFF], you cannot use the Scan To Computer function and Remote
Scan.
1.
Press [Device Settings] on the touch panel.
2.
Press or several times to select [Admin Setup].
3.
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "aaaaaa"
respectively.
4.
Press [Scanner Setup].
5.
Press [TWAIN Setup].
6.
Check that [Network TWAIN] is set to [ON].
Memo
Pressing [Network TWAIN] switches between [ON] and [OFF].
7.
Press [Back] until the home screen is displayed.
Selecting a Remote Scan Mode
There are three Remote Scan modes: Simple Scan, Manual Scan, and Secure Scan.
In Simple Scan mode, you can start scanning anytime if the machine is in standby status.
In Manual Scan mode, you must turn Remote Scan on the touch panel before starting
scanning.
In Secure Scan mode, you can operate only from a specified computer. Only one computer
can be connected at a time.
If you perform a remote scan via the WSD Scan connection, you can start scanning only
from computers that are already registered in this machine, regardless of the Remote Scan
modes.
1.
Press [Device Settings] on the touch panel.
2.
Press or several times to select [Admin Setup].
254