Server Technology Switched Rack PDU Installation And Operation Manual - page 104
104 Advanced Operations
Switched PDU
Installation and Operations Manual
SNMP v3 Command Summary
Command
Description
Set SNMP IP Restrict
Allows SNMP Get and Set requests from defined trap destinations only
Set SNMP Trap Format
Configures the SNMP trap format version
Set SNMP V3
Enables or disables SNMP v3 support
Set SNMP V3 RO Username
Sets the SNMP V3 read-only username.
Set SNMP V3 RO Auth Type
Sets the SNMP V3 read-only authentication type
Set SNMP V3 RO Auth Password
Sets the SNMP V3 read-only authentication password
Set SNMP V3 RO Priv Type
Sets the SNMP V3 read-only privacy type
Set SNMP V3 RO Priv Password
Sets the SNMP V3 ready-only privacy password
Set SNMP V3 RW Username
Sets the SNMP V3 read-write username
Set SNMP V3 RW Auth Type
Sets the SNMP V3 read-write authentication type
Set SNMP V3 RW Auth Password Sets the SNMP V3 read-write authentication password
Set SNMP V3 Trap Username
Sets the SNMP V3 trap username for display on SNMP activity logs
Set SNMP V3 RW Priv Type
Sets the SNMP V3 read-write privacy type
Set SNMP V3 RW Priv Password Sets the SNMP V3 ready-write privacy password
Show SNMP
Displays all SNMP configuration information
MIB, OID, and Support
The SNMP MIB and OID are available on the Server Technology website:
ftp://ftp.servertech.com/pub/SNMP/sentry3
Technical support is available 8:00AM to 5:00 PM Pacific Time, Monday-Friday.
For SNMP Support, email: mibmaster@servertech.com
Enabling and Setting up SNMP Support
SNMP support must be enabled and configured for access to Sentry3 MIB objects and generation of all Sentry3 traps.
Enabling/disabling SNMP support:
The SNMP command is used to enable or disable SNMP support.
To enable SNMP support:
At the Switched CDU: prompt, type set snmp v3, followed by enabled or disabled and press Enter.
NOTE: A restart of the PDU is required after enabling or disabling SNMP support.
SNMPv3 Engine ID:
The local engine ID is the unique identifier for the SNMPv3 engine and is displayed for viewing.
Setting the SNMP v3 read-only (RO) username :
The Set SNMP RO Username command sets the read-only username for SNMP v3. A valid username can be set to
any value between 1-32 characters.
To set the RO username:
At the Switched CDU: prompt, type set snmp v3 rousername, and press Enter.
NOTE: You can set a blank username but doing so will clear the string and disallow any read-only user access.
Setting the SNMP v3 read-only (RO) authentication type :
The Set SNMP RO Auth Type command sets the SNMP v3 RO authentication type.
To set the RO authentication type:
At the Switched CDU: prompt, type set snmp v3 roauthtype, followed by none or md5, and press Enter.