Server Technology Switched Rack PDU Installation And Operation Manual - page 38
38 Operations Switched PDU
Installation and Operations Manual
Input Feeds
The Input Feeds configuration page allows you to assign and edit input feed descriptive names, operational voltage,
and maximum load capacity.
Creating a descriptive input feed name:
In the Input Feed Name field, enter a descriptive name and click Apply.
Setting the infeed operational voltage:
In the Input Feed Voltage field, enter a value from 1 to 480 and click Apply.
NOTE: If Smart Load-Shedding has been activated and UPS voltage polling configured for an infeed, the polled voltage value will be used
for all power calculations.
Setting the infeed maximum load capacity:
In the Input Feed Load Capacity field, enter a value from 1 to 255 and click Apply.
UPS
The UPS Configuration page allows adding a new UPS device and configuring the UPS devices connected to the
Switched PDU.
NOTE: The UPS page accepts both IPv4 and IPv6 formats in the Hostname/IP field.
To add a new UPS:
Select the UPS manufacturer type from the Type drop-down list, type an IP address (or hostname) for the UPS, and click
Apply.
To edit the UPS type:
Under the Action heading, click the Edit link for the UPS to be configured. The Configuration UPS page reformats to
an edit page where UPS device settings are configured and UPS devices are associated with an infeed.
Selecting the UPS type:
Select the UPS manufacturer type from the UPS Type drop-down list and click Apply.
Editing the UPS Hostname/IP Address:
In the Hostname/IP field, type an IP Address or Hostname and click Apply.
Editing the UPS SNMP GET community string:
In the SNMP GET Community String field, type the community string configured on the UPS device and click
Apply.
Enabling/Disabling UPS voltage polling:
From the Poll UPS Voltage drop-down list, select Enabled or Disabled and click Apply.
Editing the UPS SNMP port number:
In the Port field, type the port number and click Apply.
Associate the UPS with an infeed:
Select the infeed(s) powered by the UPS and click Apply.
To remove a UPS:
On the Configuration UPS page, under the Action heading, click the Remove link for the UPS you want to remove.