Server Technology Switched Rack PDU Installation And Operation Manual - page 140
140 Advanced Operations
Switched PDU
Installation and Operations Manual
Enabling or disabling event notification types:
The Set Email Event, Set Email Auth, Set Email Power, and Set Email Config commands enable or disable email
notification of the event types.
To enable or disable event notification types:
At the Switched CDU: prompt, type set email, followed by event, auth, power or config and enabled or disabled.
Press Enter.
Examples
The following command sets the enables email notification general system events:
Switched CDU: set email event enabled
The following command sets the disables email notification authentications attempts:
Switched CDU: set email auth disable
Sending a test email:
The Set Email Test command sends a test email to the target email destinations.
At the Switched CDU: prompt, type set email test, and press Enter.
Displaying Email configuration information:
The Show Email command displays Email configuration information.
To display the Email configuration information:
At the Switched CDU: prompt, type show email and press Enter.
Example
The following command displays the Email configuration information:
Switched CDU: show email
Email/SMTP Configuration
Email Notifications: Enabled
SMTP
Host: email.servertech.com
Port: 25
Authentication Type:
Any
Authenticate With: 'From' Address
Username:
djones
Password: ********
'From' Address: Sentry3_50e021@
Primary 'Send To' Addr: techsupport@servertech.com
Secondary 'Send To' Addr:
Subject ID: [Sentry3_5246401]
EVENT Messages: Enabled
AUTH Messages: Disabled
POWER Messages: Disabled
CONFIG Messages: Disabled