Server Technology Switched Rack PDU Installation And Operation Manual - page 92
92 Operations Switched PDU
Installation and Operations Manual
Changing the UPS type:
The Set UPS Type command is used to change the type of UPS for each UPS record.
To change a UPS record:
At the Switched CDU: prompt, type set ups type and press Enter.
At the prompt, type the index number for the UPS record to be changed and press Enter.
At the prompt, type the corresponding number from the list of the UPS types and press Enter.
Example
The following command changes UPS type for the record at index number 2 to ‘MGE’:
Switched CDU: set ups type
1 Type: Liebert
Host/IP: DC1Liebert1
2 Type: Powerware
Host/IP: DC1Powerware1
Select UPS(1-8): 2
UPS types:
1 -- APC
2 -- Liebert
3 -- MGE
4 -- Tripp Lite
5 -- Generic (RFC1628)
6 -- Hewlett Packard
7 -- Minuteman
8 -- Mitsubishi
9 -- Powerware
10 -- Toshiba
11 -- Falcon Electric
Select type(1-11): 3
Changing the UPS host address:
The Set UPS Host command is used to change the IP address or hostname for each UPS record. Hostnames can be up
to 60 characters long.
To change a UPS host address:
At the Switched CDU: prompt, type set ups host and press Enter.
At the prompt, type the index number for the UPS record to be changed and press Enter.
At the prompt, type IP address or hostname for the UPS and press Enter.
Example
The following command changes UPS hostname for the record at index number 2 to ‘DC1MGE1’:
Switched CDU: set ups host
1 Type: Liebert
Host/IP: DC1Liebert1
2 Type: MGE
Host/IP: DC1Powerware1
Select UPS(1-8): 2
Host/IP: DC1MGE1