Server Technology Switched Rack PDU Installation And Operation Manual - page 72
72 Operations Switched PDU
Installation and Operations Manual
Environmental Monitor Administration
Creating a descriptive Environmental Monitor name:
The Set Envmon Name command assigns a descriptive name to the integrated Environmental Monitor. This
descriptive name is displayed when the Evnmon command is issued.
To create an Environmental Monitor name:
At the Switched CDU: prompt, type set envmon name followed by the absolute environmental monitor name, then
the descriptive name of up to 24 alphanumeric and other typed characters - (ASCII 33 to 126 decimal) are allowed;
spaces are not allowed. Press Enter.
Example
The following command adds the descriptive name Florida_HQ_1to the Environmental Monitor:
Switched CDU: set envmon name .a Florida_HQ_1
Creating a descriptive temperature/humidity sensor name:
The Set Envmon THS Name command assigns a descriptive name to a temperature/humidity sensor. This descriptive
name is displayed when the Evnmon command is issued.
To create an temperature/humidity sensor name:
At the Switched CDU: prompt, type set envmon ths name followed by the absolute name of the
temperature/humidity sensor, then the descriptive name of up to 24 alphanumeric and other typed characters - (ASCII
33 to 126 decimal) are allowed; spaces are not allowed. Press Enter.
Example
The following command adds the descriptive name T/H2_Florida_HQ_1 to the second temperature/humidity sensor:
Switched CDU: set envmon ths name .a2 T/H2_Florida_HQ_1
Serial Port Administration
Creating a descriptive serial port name:
The Set Port Name command assigns a descriptive name to a serial port. You can use this name in commands that
require a port name as an alternative to using the port’s absolute name.
To create an port name:
At the Switched CDU: prompt, type set port name followed by the absolute outlet name, then a descriptive name of
up to 24 alphanumeric and other typed characters - (ASCII 33 to 126 decimal) are allowed; spaces are not allowed;
port names are not case sensitive. Press Enter.
Example
The following command adds the descriptive name Rack1 to Console port:
Switched CDU: set port name console Rack1
Setting the serial ports data-rate:
The Set Port Speed command sets the default data-rate for the serial port.
Valid data-rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600 and 115200.
To set the serial port data-rate:
At the Switched CDU: prompt, type set port speed, follow by the data-rate and press Enter.
Example
The following command sets the serial ports data-rate to 38400 BPS:
Switched CDU: set port speed 38400
Enabling or disabling active signal checking for serial connections:
The Set Port DSR Check command enables or disables active signal checking for serial connections to devices
attached to any of the available serial ports.
To enable or disable active signal checking for serial connections:
At the Switched CDU: prompt, type set port dsrcheck console, on or off, and press Enter.