Server Technology Switched Rack PDU Installation And Operation Manual - page 74
74 Operations Switched PDU
Installation and Operations Manual
Enabling or disabling the Command Line Interface (CLI):
This option enables or disables availability of the CLI for issuing action commands to the PDU. If disabled, only the
firmware Web user interface will be available.
To enable or disable the CLI:
At the Switched CDU: prompt, type set port cli, follow by the serial port name, followed by enabled or disabled,
and press Enter.
Enabling or disabling the Serial Command Protocol (SCP):
This option allows SCP functions to be enabled or disabled for a specific serial port.
To enable or disable the SCP:
At the Switched CDU: prompt, type set port scp, follow by the serial port name, followed by enabled or disabled,
and press Enter.
Enabling or disabling the Serial Command Protocol (SCP) emulation:
This option notifies SCP of an MRV device on a specific serial port.
To enable or disable the SCP emulation:
At the Switched CDU: prompt, type set port scp, followed by emulate, followed by none or MRV, and press Enter.
Enabling or disabling the RFTAG option:
This option makes RF Code sensor tags available for the Server Technology wireless monitoring solution.
To enable or disable the RF Code sensor options:
At the Switched CDU: prompt, type set port rftag, follow by the serial port name, followed by enabled or disabled,
and press Enter.
Displaying serial port information:
The Show Ports command displays information about all serial ports. This information includes:
Serial port data rate
Descriptive port name, if applicable
DSR signal checking settings
Bluetooth™ parameter settings, if applicable
To display serial port information:
At the Switched CDU: prompt, type show ports and press Enter.
Example
The following command displays all serial port information:
Switched CDU: show ports
Serial Port Configuration
Port ID: Console
Port Name: CONSOLE
DSR Check: ON
CLI: Enabled SCP: Disabled RFTAG: Enabled
Data Rate: 9600 Connection Timeout: 5 minutes
Port ID: Aux
Port Name: AUX
DSR Check: ON
CLI: Enabled SCP: Enabled
Data Rate: 115200 Connection Timeout: 5 minute
Bluetooth Settings:
Name: ST Eye – 10.1.2.77
Discoverability: LIMITED
Pin code: 9611
Transmission pwr: 0
Command successful