Server Technology Switched Rack PDU Installation And Operation Manual - page 37
Switched PDU
Installation and Operations Manual
Operations 37
Configuring the
Bluetooth™ options:
If the PDU has been equipped for the mobile monitoring solution using Bluetooth
®
technology, several Bluetooth
parameters will be available for editing on the Serial Ports configuration page.
Click the Edit link in the Action column next to the AUX port to configure the following parameters.
Provide a value as described for each parameter field, and click Apply.
Firmware Bluetooth Parameters
Parameter
Description and Valid Values/Range
Bluetooth Name
Descriptive name of the Bluetooth module that displays in the list of discovered modules
on the Android device. The default module name is “ST Eye”. The name cannot be blank;
Valid range is 1-31 characters.
Bluetooth Discoverability Settings that determine the current status of the pushbutton on the Bluetooth module.
Always – The Bluetooth module is discoverable, even without pressing the pushbutton.
Limited – (Default). The pushbutton on the Bluetooth module must be pressed to make
the module discoverable for 60-seconds.
Never – The Bluetooth module is never in discoverable mode.
Bluetooth Pin Code
The pin code is available for legacy Bluetooth modules that require a pin to pair the module.
Although not used in current Bluetooth modules, the pin code is supported if needed.
Default is 9611; must be 4-digits; range is 0000 to 9999.
Bluetooth Transmission Power Designated transmission power (dbm) for the Bluetooth module. Note that lowering the
transmission power reduces the effective range of the module. Default is 0;
range is -6 to 4 dbm.
Towers
The Towers configuration page is used for assignment and/or editing of:
Descriptive names
Serial and Model numbers
Operation voltage types
NOTE: If set at the factory, you cannot edit the serial number, model number, or voltage type.
Creating a descriptive tower name:
In the Tower Name field, enter a descriptive name and click Apply.
Setting the tower serial number:
In the Serial Number field, enter the serial number of the unit and click Apply.
Setting the tower model number:
In the Model Number field, enter the model number of the unit and click Apply.
Setting the operational AC or DC voltage type:
From the AC/DC drop-down menu, select AC or DC, and click Apply.
Setting the operational AC voltage type:
From the 3-Phase drop-down menu, select yes or no, and click Apply.