Server Technology Switched Rack PDU Installation And Operation Manual - page 84
84 Operations Switched PDU
Installation and Operations Manual
Setting the IP address:
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the Switched CDU: prompt, type set ipaddress, followed by the IP address and press Enter.
NOTE: Both IPv4 and IPv6 IP address formats are accepted.
Example
The following command sets the IP address to 12.34.56.78:
Switched CDU: set ipaddress 12.34.56.78
Setting the subnet mask:
The Set Subnet command sets the subnet mask for the network the PT40 will be attached to.
To set the subnet mask:
At the Switched CDU: prompt, type set subnet, followed by the subnet mask and press Enter.
Example
The following command sets the subnet mask to 255.0.0.0
Switched CDU: set subnet 255.0.0.0
Setting the gateway:
The Set Gateway command sets the IP address of the default gateway the PDU uses to access external networks.
To set the gateway IP address:
At the Switched CDU: prompt, type set gateway, followed by the gateway IP address and press Enter.
Example
The following command set the gateway IP address to 12.34.56.1:
Switched CDU: set gateway 12.34.56.1
Setting the DNS IP address:
The Set DNS command sets the TCP/IP address of the Domain Name server (DNS).
To set the DNS IP address:
At the Switched CDU: prompt, type set, followed by dns1 or dns2 and the Domain Name server’s IP address. Press
Enter.
NOTE: Both IPv4 and IPv6 formats are accepted for DNS IP address.
Example
The following command sets the primary Domain Name server IP address to 98.76.54.254:
Switched CDU: set dns1 98.76.54.254
Displaying network configuration information:
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL, SNMP, and DHCP options (when DHCP is
enabled) configuration information. The Show Network command also displays all IPv4 and IPv6 settings.
Network configuration: IP address, subnet mask, gateway and DNS IP addresses (both IPv4 and IPv6
formats are displayed). (both IPv4 and IPv6 formats are displayed).
Enabled-disabled status and port numbers for Telnet, SSH, HTTP, SSL, SNMP, and FTP Server support.
Network status: Link, speed, duplex, and negotiation.
DHCP boot delay and DHCP static address fallback options (when DHCP is enabled).
Enabled-disabled status of Sentry Power Manager (SPM).