Server Technology Switched Rack PDU Installation And Operation Manual - page 139
Switched PDU
Installation and Operations Manual
Advanced Operations 139
Changing the SMTP server port:
With SMTP support enabled, the PDU sends SMTP requests to the default SMTP port number 25. You can change this port
number using the Set Email SMTP Port command.
To change the TACACS port:
At the Switched CDU: prompt, type set email smtp port, followed by the port number and press Enter.
Example
The following changes the SMTP port number to 5555:
Switched CDU: set email smtp port 5555
Setting the ‘From’ email address:
The Set Email From command sets the “from” email address. By default, this is set to ‘Sentry3_’ plus the last three
octets of the unit’s MAC address. Example: ‘Sentry3_510c90@’
To set the ‘From’ email address:
At the Switched CDU: prompt, type set email from, followed by the originating email address and press Enter.
Example
The following command sets the ‘from’ email address to Rack14PDU1@servertech.com:
Switched CDU: set email from Rack14PDU1@servertech.com
Setting the ‘Send To’ email address:
The Set Email PrimaryTo and Set Email SecondaryTo commands set the recipient email addresses.
To set the ‘Send To’ email address:
At the Switched CDU: prompt, type set email, followed by primaryto or secondaryto and the destination email
address. Press Enter.
If the primary ‘send to’ address fails, the system then attempts to send the email to the secondary ‘send to’ address.
Examples
The following command sets the primary ‘to’ email address to DayAdmin@servertech.com:
Switched CDU: set email primaryto DayAdmin@servertech.com
The following command sets the secondary ‘to’ email address to NiteAdmin@servertech.com:
Switched CDU: set email secondaryto NiteAdmin@servertech.com
Setting the Email SMTP authentication username:
The Set Email SMTP Username command sets the username for SMTP authentication.
At the Switched CDU: prompt, type set email smtp username, followed by the SMTP username, and press Enter.
Spaces are not allowed.
Setting the Email SMTP authentication password:
The Set Email SMTP Password command sets the password for SMTP authentication with username.
At the Switched CDU: prompt, type set email smtp password, followed by the SMTP password, and press Enter.
Setting the Email SMTP Use Username :
The Set Email SMTP Useusername command uses the SMTP username for SMTP authentication.
At the Switched CDU: prompt, type set email smtp useusername, followed by the username, and press Enter.
Setting the Email SMTP Use ‘From’ Address:
The Set Email SMTP Usefromaddr command uses the SMPT ‘From’ address for SMTP authentication.
At the Switched CDU: prompt, type set email smtp usefromaddr, and press Enter