Server Technology Switched Rack PDU Installation And Operation Manual - page 88
88 Operations Switched PDU
Installation and Operations Manual
Setting the FTP Password:
The Set FTP Password command sets the password as required by the FTP Host.
To set the FTP password:
At the Switched CDU: prompt, type set ftp password, followed by the FTP password and press Enter.
Example
The following command sets the FTP password to Test1:
Switched CDU: set ftp password Test1
Setting the filename to be uploaded:
The Set FTP Filename command sets the filename of the firmware file to be uploaded.
To set the FTP filename:
At the Switched CDU: prompt, type set ftp filename, followed by the firmware filename and press Enter.
Example
The following command sets the FTP filename to snb_s50a.bin:
Switched CDU: set ftp filename swcdu-v60g.bin
Setting the directory for the file to be uploaded:
The Set FTP Directory command sets the directory for the firmware file to be uploaded.
To set the FTP directory:
At the Switched CDU: prompt, type set ftp directory, followed by the directory and press Enter.
Example
The following command sets the FTP directory to ftp://Sentry:
Switched CDU: set ftp directory ftp://sentry
Enabling or disabling automatic updates:
The Set FTP Autoupdate command is used to enable or disable automatic firmware update support.
To enable or disable automatic updates:
At the Switched CDU: prompt, type set ftp autoupdate, followed by enabled or disabled and press Enter.
Setting the automatic update scheduled day:
The Set FTP Autoupdate Day command is used to set the day when automatic updates occur.
To set the automatic update day:
At the Switched CDU: prompt, type set ftp autoupdate day, followed bya day of the week or everyday and press Enter.
Example
The following command sets the automatic update day to Sunday:
Switched CDU: set ftp autoupdate day sunday
Setting the automatic update scheduled hour:
The Set FTP Autoupdate Hour command sets the hour of the day when automatic updates occur.
To set the automatic update hour:
At the Switched CDU: prompt, type set ftp autoupdate hour, followed byan hour of the day and press Enter.
Examples
The following command sets the automatic update hour to 12 AM:
Switched CDU: set ftp autoupdate hour 12am
The following command sets the automatic update hour to 3 PM:
Switched CDU: set ftp autoupdate hour 3pm