Server Technology Switched Rack PDU Installation And Operation Manual - page 137
Switched PDU
Installation and Operations Manual
Advanced Operations 137
Setting the Syslog server IP address:
The Set Syslog HostIP command sets the TCP/IP address of the Syslog server.
To set the Syslog server IP address:
At the Switched CDU: prompt, type set syslog, followed by hostip1 or hostip2 and the Syslog server’s IP address.
Press Enter.
Example
The following command sets the primary Syslog server IP address to 56.47.38.29:
Switched CDU: set syslog hostip1 56.47.38.29
Changing the Syslog server port:
With Syslog support enabled, the Syslog server watches and responds to requests on the default Syslog port number
514. You can change this port number using the Set Syslog Port command.
To change the Syslog port:
At the Switched CDU: prompt, type set syslog port, followed by the port number and press Enter.
Example
The following changes the Syslog port number to 411:
Switched CDU: set syslog port 411
Displaying Syslog configuration information:
The Show Syslog command displays Syslog configuration information.
To display the Syslog configuration information:
At the Switched CDU: prompt, type show syslog and press Enter.
Example
The following command displays the Syslog configuration information:
Switched CDU: show syslog
SYSLOG Configuration
Primary Syslog Server IP Address: 56.47.38.29
Secondary Syslog Server IP Address: 0.0.0.0
Syslog Server Port: 411