Server Technology Switched Rack PDU Installation And Operation Manual - page 108
108 Advanced Operations
Switched PDU
Installation and Operations Manual
Displaying SNMP configuration information:
The Show SNMP command displays all SNMP configuration information.
SNMP version (v2/v3) support status (enabled/disabled)
SNMP community strings
Read-Only (RO) or Read-Write (RW) username, authentication type, privacy type (if SNMPv3)
Trap username
Trap destination(s)
IP restrictions setting
Error trap repeat time (in seconds)
Sysname, syslocation, and syscontact
To display SNMP configuration information:
At the Switched CDU: prompt, type show snmp and press Enter.
Example
The following command displays the SNMP configuration information:
Switched CDU: show snmp
SNMP Configuration
SNMPv2 Agent: Enabled
GET Community
SET Community
TRAP Community: trap
SNMPv3 Agent: Disabled
Engine ID 800006B602000000000000000000000FFFF0A010249
RW Username:
RW Auth Type: None
RW Privacy Type: None
RO Username:
RO Auth Type: None
RW Privacy Type: None
Trap Username
Trap Destination 1:
Trap Destination 2:
Trap format: v3
IP Restrictions: No Restrictions
Error Trap Repeat Time: 60 second
SysName: Sentry3_524640
SysLocation: No Location
SysContact: No Contact
Command successful