Server Technology Switched Rack PDU Installation And Operation Manual - page 48
48 Operations Switched PDU
Installation and Operations Manual
Adding and deleting outlet group access:
Click on the Groups link in the Access column for the associated LDAP Group.
On the subsequent LDAP Group - Groups page, select or deselect outlet groups to be accessed by the LDAP Group
and click Apply.
Adding and deleting serial port access:
Click on the Ports link in the Access column for the associated LDAP Group.
On the subsequent LDAP Group - Ports page, select or deselect ports to be accessed by the LDAP Group and click Apply.
TACACS+
The TACACS+ configuration page is used for setup and maintenance of all settings required to enable TACACS+ support.
For more information and the configuration requirements, see the “TACACS+” section.
Enabling or disabling TACACS+ support:
Select Enabled or Disabled from the TACACS+ drop-down menu and click Apply.
Setting the TACACS+ server address:
Enter the IP address or hostname in the Primary and/or Secondary Host field and click Apply.
NOTE: Both IPv4 and IPv6 formats are accepted in the Primary/Secondary Host fields.
Changing the TACACS+ server port:
Enter the port number in the Port field and click Apply.
Configuring the authentication order:
Select Remote > Local or Remote Only from the drop-down menu and click Apply.
For more information about remote authentication order, see the “Setting the authentication order” section.
NOTE: Server Technology recommends not setting the authentication order to Remote Only until TACACS has been fully configured and
tested.
Setting the TACACS+ encryption key:
Enter a key and verify the new key the Encryption Key and Verify Encryption Key fields. Press Apply.
For security, key characters are not displayed.
Configuring TACACS+ privilege levels:
Click on the TACACS+ Privilege Levels link at the bottom of the page.
Changing an TACACS+ Privilege Level’s access privilege level:
Click on the Edit link in the Action column for the associated TACACS+ Privilege Level.
On the subsequent TACACS+ Privilege Level - Edit page, select Admin, User, On-only or View-only from the
Access Level drop-down menu and click Apply.
Granting or removing environmental monitoring viewing privileges:
Click on the Edit link in the Action column for the associated TACACS+ privilege level.
On the subsequent TACACS+ Privilege Level - Edit page, select Yes or No from the Environmental Monitoring
drop-down menu and click Apply.
NOTE: Granting access to environmental monitoring (temperature/humidity/sensors) to a non-admin user also grants that user access to
power monitoring (outlets, infeeds, towers – all the environmental data of the PDU).