B&R Industries Provit 5000 User Manual - page 131
130
Provit 5000 User’s Manual
Controllers • Bus Unit
9.3.2 Fasteners for Full Size Cards
Fasteners for full size cards are contained in the delivery of Provit 5600 bus units (model no:
5C56xx.xx). The fasteners consist of a guide rail and a mounting screw. They are connected by
attaching screws to openings in the housing, above and below the card, thus providing increased
stability to the card.
If components are positioned on the edge of the full size card, it is possible that the card does
not fit in the guide rail correctly. In this case, the guide rail must be sawed off where required.
9.4 Hard Disk / Silicon Disk Slots
There is a slot available in the Provit 5000 controller to connect mass memory media using an
IDE interface. Two IDE devices can be installed in the Provit 5600 controller.
A PCI plug is used to connect (mechanically or electrically) the hard drive to the IPC.
However, the mass memory media does not possess a PCI interface and cannot
operate on the PCI bus (see also the section "Mass Memory").
Figure 74: Fasteners for full size cards