B&R Industries Provit 5000 User Manual - page 142
Provit 5000 User’s Manual
141
Chapt
er
2
C
on
tro
lle
rs
Controllers • Mass Memory
11.1.1 Hard Disks
A silicon disk (PC card, Compact flash) is required in environments with vibration and
shock. Hard disk drives are normally not designed for use in industrial environments.
If there is excessive vibration or shock present during the applications, B&R shall not
be liable for damage to a properly functioning hard disk. The specified limit values can
be read from the corresponding tables.
Hard drives in the 2.5" format are used exclusively.
See the section "Assignment of Resources" for I/O addresses and interrupt settings.
The top side of the hard drives should never be touched. Magnet heads can be
damaged by even light pressure because the housing plate is very thin.
Hard Disk
5A5001.02
5A5001.03
5A5001.04
5A5001.05
1)
1) More detailed information about 6 GB hard disks can be found in Chapter 8 "Technical Appendix".
5A5001.08
Capacity
1.44 GB
2.1 GB
4.3 GB
6 GB
Operating Temperature
2)
2) Operating temperature of the controller
5 - 47 °C
5 - 47 °C
5 - 40 °C at 24 h operation
Standards
Shock
Vibration
150 G, 2 ms
0.5 G, 5 to 500 Hz
150 G, 2 ms
1.0 G, 5 to 400 Hz
Table 107: Technical data hard disks
Figure 80: Hard disk mounted directly on the adapter card (Model 5A5001.03)