B&R Industries Provit 5000 User Manual - page 303
302
Provit 5000 User’s Manual
Software • BIOS for System Unit with Socket 370
Name
Description of the display for software use.
Mode
With this item you can select which display device should be
active when the system is started:
AUTO
All connected display devices are
automatically activated. If no display device is
connected then the monitor is activated
CRT
Only the monitor is activated
FPD
Only the display is activated
CRT+FPD
The monitor and display are activated
(simultaneous mode)
FPD contrast
The contrast of the connect display can be set.
Attention: This is only possible for LCD displays.
FPD brightness
The brightness of the connect display can be set. Possible
for both LCD as well as for TFT displays.
If a value (e.g. 80%) is stored in the BIOS Setup then the
BIOS uses these each time the system is started, also when
another display is connected.
CAN Detected I/O Port
If a B&R interface board is installed in your IPC, then the I/O range is shown here.
See also the section "CAN Interface".
CAN Assigned IRQ
Here, an IRQ can be assigned to the CAN port of the interface board
(disconnecting the interrupt line). You can choose between the options NONE,
IRQ10 and NMI (Non Maskable Interrupt). See also the section "CAN Interface".
PCMCIA Detected I/O Port
The I/O address range of the PCMCIA port (Socket 1) is displayed on the interface
board. See also the section "PC Card Slot/ SRAM".