B&R Industries Provit 5000 User Manual - page 275
274
Provit 5000 User’s Manual
Software • BIOS System for System Units with Socket 7 (ZIF)
MTC Communication Assigned I/O Port
Here the I/O address can be set for communication of the MTC.
Attention: Some ISA cards (e.g. network cards) always use the address range
that the MTC normally uses for communication. In this case another MTC I/O
address must be selected (see also the section "Maintenance Controller MTC").
Controller Software ID
The version numbers of BIOS, VGA BIOS and MTC are given.
Statistics
Displays the operating data which is collected using the MTC:
•
Power-on cycles
•
Operating hours
•
Over-temperature hours
•
Operating hours of the fans (Fan Cooler Hours; for display units optional, both
fans for controller unit)
See also the section "Operating Data Coverage".
CMOS Battery Status
It is displayed using the MTC, if the backup battery for the CMOS RAM is in order.
If this option has the value "Bad" then the battery should be exchanged as soon
as possible.
User Serial ID
A user serial number (32 bit, in hex format) can be entered here. This is saved in
the CMOS.
Show
When set to "Yes" the user serial number (see above, User Serial ID) is displayed
in the device window upon the system being started.