B&R Industries Provit 5000 User Manual - page 304
Provit 5000 User’s Manual
303
Chapt
er
6
So
ftw
are
Software • BIOS for System Unit with Socket 370
Hardware Security Key Detected I/O Port
The I/O address range of the Hardware Security Key is displayed. The Hardware
Security Key is available on both the mainboard (see section "LPT2 / Hardware
Security Key") and the B&R interface board (see section "LPT2 / Hardware
Security Key").
If a B&R interface board is installed in your IPC, then the I/O address range of this
Hardware Security Keys is displayed, otherwise those on the mainboard.
MTC Communication Assigned I/O Port
The I/O address can be set here for MTC communication.
Some ISA cards (e.g. network cards) use fixed address space, via
which the MTC normally also communicates. In such cases, another
MTC I/O address must be selected. Also see the section "Maintenance
Controller MTC".
User Serial ID
A user serial number (32 bit, in hex format) can be entered here. It is stored in
CMOS.
Show
When set to "Yes" the user serial number (see "User Serial ID" above) is displayed
in the device window when the system is started.
Controller HW ID
Hardware Identification number.
Controller SW ID
The version numbers of BIOS, FPGA, VGA-BIOS and MTC are given.
Show
Here you can toggle between different operating data, which is collected using the
MTC. This data is shown below.