D-Link DES-3326 User Manual - Advanced Setup
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
152
Configuring the Switch Using the Console Interface
RIP protocol will be used to interpret received RIP packets.
Disabled prevents the reception of RIP packets.
Advanced Setup
The switch operation mode setting changes the menus and
configuration options for the Advanced Setup of the switch. This
section of the manual is therefore divided into two sections for each
Advanced Setup menu item to reflect the two switch operation
modes – Layer 2 with IEEE 802.1Q VLAN support and IP
Routing with IEEE 802.1Q VLAN support. Where there is no
difference in the setup between the two switch operation modes,
only one section will be presented.
Configuring VLANs
Note: The switch allows the assignment of an IP
interface to each VLAN, in IP Routing mode. The
VLANs must be configured before setting up the IP
interfaces. VLANs in Layer 2 Only Mode
The switch reserves one VLAN, VID = 1, called the
DEFAULT_VLAN for internal use. The factory default setting
assigns all ports on the switch to the DEFAULT_VLAN. As new
VLANs are configured, there respective member ports are removed
from the DEFAULT_VLAN. If the DEFAULT_VLAN is
reconfigured, all ports are again assigned to it. Ports that are not
desired to be part of the DEFAULT_VLAN are removed during the
configuration.