D-Link DES-3326 User Manual - page 286
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
272
Web-Based
Network
Management
Multicasting – Dense Mode (PIM-
DM) multicasting protocol.
Setup IP Interface
The first menu displays the current IP interfaces on the switch.
The Add and Edit menus are used to add a new IP interface, and to
edit an existing IP interface, respectively.
Each IP interface on the switch corresponds to a VLAN. The
VLAN must be configured before the IP interface can be setup.
The IP interface must have the same name (and the same VID
number) as its corresponding VLAN.
Note: A VLAN that does not have a corresponding IP interface
defined for it, will function as a Layer 2 Only VLAN – regardless
of the Switch Operation mode.
Figure 7-18. Setup IP Interface Screen
Parameter
Description
System
Displays the name of the IP interface
corresponding to the IP address and subnet
mask below.
IP Address
The IP address of the IP interface
(sometimes referred to as a network
address).
Subnet Mask
The subnet mask corresponding to the IP
address and IP interface name above.