D-Link DES-3326 User Manual - page 291
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Web-Based Network Management
277
Subnet Name
Displays the name of the subnet on which
RIP is to be edited. This subnet must be
previously configured on the switch.
IP Address
Displays the IP address corresponding to
the subnet name above.
Tx Mode
Allows transmitted RIP packets to be
structured as V1 only, V1 Compatible,
V2 Only, or Disabled. This entry specifies
which version of the RIP protocol will be
used to transmit RIP packets. Disabled
prevents the transmission of RIP packets.
Rx Mode
Determines how received RIP packets will
be interpreted – as RIP version V1 only,
V2 Only, V1 and V2, or Diabled. This
entry specifies which version of the RIP
protocol will be used to receive RIP packets.
The Disabled entry prevents the reception
of RIP packets.
Auth.
Allows RIP to be configured to use an
authorization string.
Port Configuration
The following figure and table describe the configuration of ports
on the switch. You can select a port to be configured by clicking on
the port in Area 1 (the switch icon at the top of the web-based
manager’s user interface). This port then becomes the currently
selected port and all entries in the following figure will apply to
this port.