D-Link DES-3326 User Manual - page 230
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
216
Configuring the Switch Using the Console Interface
Figure 6-76. BOOTP/DHCP Relay Setup – Layer 3
The BOOTP/DHCP:field can be toggled between
Disabled and Enabled using the space bar. The BOOTP HOPS
Count Limit [4 ] determines the number of router hops the relay
will be allowed to cross. A hop count between 1 and 16 can be
entered. The BOOTP/DHCP Relay Time Threshold:[4 ] Sets
the minimum time (in seconds) that the switch will wait before
forwarding a BOOTREQUEST packet. If the value in the seconds
field of the packet is less than the relay time threshold, the packet
will be dropped.
To enter the IP addresses of BOOTP Relay servers:
Highlight BOOTP/DHCP Relay Interface Configuration and
press Enter.
Figure 6-77. BOOTP/DHCP Relay Setup – Layer 3
Toggle to Add and enter the subnet name for which BOOTP Relay
will be active. The subnet’s network IP address will be displayed
in the IP: field. Enter the IP address of the BOOTP Relay server