D-Link DES-3326 User Manual - Layer 2 Only and Ip Routing
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Configuring the Switch Using the Console Interface
153
Packets cannot cross layer 2 VLANs. If a member of one layer 2
VLAN wants to connect to another layer 2 VLAN, it must be
through a router.
VLANs by Switch Operating Mode –
Layer 2 Only and IP Routing
Note:The switch’s default - in both Layer 2 Only mode
and IP Routing mode - is to assign all ports to a single
802.1Q VLAN named DEFAULT_VLAN
.
As new VLANs
are created, the member ports assigned to the new VLAN
will be removed from the default VLAN port member list.
Note: The DEFAULT_VLAN has a VID = 1. An IP
interface called System in the IP interface entry menu also
has a VID = 1, and therefore corresponds to the
DEFAULT_VLAN.
To create a new 802.1Q VLAN:
The VLAN menu adds an entry to edit the VLAN definitions and to
configure the port settings for IEEE 802.1Q VLAN support.
Highlight VLANs from the Main Menu and press enter.