D-Link DES-3326 User Manual - page 221
DES-3326 Layer 3 Fast Ethernet Switch User’s Guide
Configuring the Switch Using the Console Interface
207
Figure 6-68. Link Aggregation Setup
Toggle the Group ID:[1] field to one of the six possible link
aggregation groups configurable on the switch. Toggle the Master
Module:field to configure a group either on the Base
Unit (the 24 Fast Ethernet ports) or on the Slot-1 (optional) module
(the 2 Gigabit Ethernet ports).
Note: The two (optional) Gigabit ports can only be grouped
together as a link aggregation group. They cannot be
combined with Fast Ethernet ports in a link aggregation
group.
Specify the Group Width:[2]. This is the number of ports, in
sequential order from the base port, that will be included in the
link aggregation group.
The Method:field can be toggled between Enabled
and Disabled – and is used to turn a link aggregation group on or
off. This is useful for diagnostics, to quickly isolate a bandwidth