Jeep Wrangler 1997 Manual - page 1009
(2) Insert cable end into opening in steering col-
umn hub under ignition lock. Push cable inward
until lock tab engages.
(3) Connect the cable end eyelet onto shifter
bellcrank pin.
(4) Place gear selector in PARK.
(5) Push the spring-loaded cable adjuster forward
and snap cable into bracket.
(6) Adjust the brake transmission shifter interlock
cable. Refer to the Adjustment portion of this section
for proper procedures.
(7) Verify that the cable adjuster lock clamp is
pushed downward to the locked position.
(8) Test the park-lock cable operation.
(9) Install the floor console and related trim.
(10) Install tie strap to hold cable to base of steer-
ing column.
(11) Install lower steering column shroud and igni-
tion lock.
(12) Install lower steering column cover.
VALVE BODY
REMOVAL
(1) Raise vehicle.
(2) Remove oil pan and drain fluid.
(3) Loosen clamp bolts and remove throttle and
manual valve levers from manual lever shaft.
(4) Remove park/neutral position switch.
(5) Remove filter from valve body.
(6) Depress retaining clip and pull solenoid wire
from case connector (Fig. 27).
Fig. 26 Cable and Shifter
Fig. 27 Solenoid Wire Connector
TJ
TRANSMISSION AND TRANSFER CASE
21 - 103
REMOVAL AND INSTALLATION (Continued)