Jeep Wrangler 1997 Manual - page 860
(4) Connect the head lamp, turn signal, marker
lamp and horn wire harness connectors.
(5) Install the bolts attaching the radiator support
rods to the grille panel.
(6) If A/C equipped:
(a) Connect the high and low pressure lines at
the quick disconnect couplings.
(b) Evacuate and charge the system.
(7) Install the radiator and shroud to the grille
panel.
(8) Install the radiator overflow bottle.
(9) Install the crossmember valence cover.
(10) Install the front crossmember cover.
HOOD
REMOVAL
(1) Raise and support the hood.
(2) Disconnect the underhood lamp wire harness
connector.
(3) Disconnect the windshield washer nozzles.
(4) Disconnect the ground strap.
(5) Mark the position of the hinges on the hood for
installation alignment reference.
(6) Remove the screws attaching the hood to the
hinge and remove the hood (Fig. 2).
(7) If the hood must be replaced, remove and
transfer
the
insulator
panel,
hinges,
latches,
bumpers, brackets, footman loop, hood lamp, support
rod, and safety latch to the replacement hood (Fig.
2).
INSTALLATION
(1) Position the hood on the vehicle and install the
screws attaching the hinge to the hood.
(2) Align the hinges with the installation reference
marks on the hood and tighten the hinge screws
securely.
(3) Connect the underhood lamp wire harness con-
nector.
(4) Connect the windshield washer nozzles.
(5) Connect the ground strap.
(6) Close the hood.
Fig. 2 Hood Components
Fig. 1 Grille Bumpers
23 - 14
BODY
TJ
REMOVAL AND INSTALLATION (Continued)