Jeep Wrangler 1997 Manual - page 877
(4) Install the weatherstrip in the weatherstrip
channel ensuring that the weatherstrip is fully
engaged in the weatherstrip channel.
(5) Install window retaining sleeve.
(6) Install trim panel.
HALF DOOR WINDOW
REMOVAL
(1) Open the door.
(2) Grasp the window at both front and rear edges
and firmly lift upward (Fig. 42).
INSTALLATION
(1) Starting at the most forward alignment pin,
position the window alignment pins into the restraint
sleeves and push downward until seated.
HARD TOP
REMOVAL
(1) Disengage latches at windshield frame (Fig.
43).
(2) Remove the bolts that attach the hard top to
the body (Fig. 44).
(3) Using a flat blade or equivalent, disconnect the
rear wiper wire harness connector (Fig. 45).
(4) Disconnect the rear washer fluid hose. Cap the
hose to prevent washer fluid leakage (Fig. 46).
(5) Remove the hard top from the vehicle.
Fig. 42 Half Window
Fig. 43 Hard Top Latch
Fig. 44 Hard Top Removal
Fig. 45 Rear Wiper Wire Harness Connector
TJ
BODY
23 - 31
REMOVAL AND INSTALLATION (Continued)