Jeep Wrangler 1997 Manual - page 886
(3) Grasp wheelhouse carpet and remove from
vehicle (Fig. 68).
INSTALLATION
(1) Position wheelhouse carpet in vehicle and
adjust as necessary.
(2) If equipped, install the Add-A-trunk.
(3) Return the rear seat to the full rearward posi-
tion.
SPORT BAR
REMOVAL
(1) Remove hard top and/or soft top.
(2) Remove the door opening frames.
(3) Remove the sunvisors.
(4) Remove the A-pillar weatherstrips strips (Fig.
69).
(5) Disengage center support bar cover zipper.
(6) Remove the bolts attaching the side support
bars to the center support bar (Fig. 70).
(7) Remove the bolts attaching the side support
bars to the windshield frame.
(8) Separate the side support bars from the vehi-
cle.
(9) Pull back the center section of the carpet and
remove the bolts attaching the sport bar to the cargo
floor panel.
(10) Lower the rear seat and lift rear seat to the
full forward position.
(11) Pull back wheelhouse carpet and remove bolts
attaching the directional cross bars to the wheel-
house.
(12) Remove
the
bolts
attaching
the
seatbelt
anchors to the wheelhouse.
(13) Disconnect sound bar. Refer to Group 8F,
Audio Systems for removal and installation proce-
dures.
(14) Carefully lift the sport bar upward and
remove it from the vehicle.
Fig. 68 Vehicle Carpet
23 - 40
BODY
TJ
REMOVAL AND INSTALLATION (Continued)