Jeep Wrangler 1997 Manual - page 1087
(9) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing from inside the annulus
gear opening in the case. (Fig. 49).
(10) Install locating ring on new bearing.
(11) Position case so forward end is facing upward.
(12) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing into case. The bearing
locating ring must be fully seated against case sur-
face (Fig. 50).
(13) Remove input gear pilot bearing by inserting
a suitably sized drift into the splined end of the input
gear and driving the bearing out with the drift and a
hammer (Fig. 51).
(14) Install new pilot bearing with Installer 5065
and Handle C-4171 (Fig. 52).
(15) Remove front bearing retainer seal with suit-
able pry tool.
(16) Install new front bearing retainer seal with
Installer 7884 (Fig. 53).
Fig. 47 Output Shaft Rear Bearing Installation
Fig. 48 Output Shaft Rear Bearing Installation Depth
Fig. 49 Input Shaft Bearing Removal
Fig. 50 Seating Input Shaft Bearing
TJ
TRANSMISSION AND TRANSFER CASE
21 - 181
DISASSEMBLY AND ASSEMBLY (Continued)