Jeep Wrangler 1997 Manual - page 874
FULL DOOR WINDOW REGULATOR
REMOVAL
(1) Remove door trim panel.
(2) Remove door glass.
(3) Loosen the bolts in the slotted holes (Fig. 33).
(4) Remove the bolts attaching the regulator to the
door inner panel.
(5) Lift the regulator upward to free it from the
slotted holes in the door inner panel.
(6) Lower the regulator and remove it through the
access hole in the door inner panel (Fig. 34).
INSTALLATION
(1) Position the regulator in the door.
(2) Align regulator bolts into slotted holes.
(3) Install bolts attaching regulator to the inner
door panel.
(4) Tighten the bolts in the slotted holes.
(5) Install door glass.
(6) Install door trim panel.
HALF DOOR TRIM PANEL
REMOVAL
(1) Remove half door window.
(2) Rotate window retainer sleeves 90°. Using a
trim stick, pry sleeve retainers from door.
(3) Remove the screws attaching trim panel to
door.
(4) Remove push-in fasteners attaching trim panel
to door with special tool C-4829.
(5) Separate the trim panel from the door.
INSTALLATION
(1) Position the trim panel on the door.
(2) Press the push-in fasteners attaching trim
panel to door into place.
(3) Install the screws attaching trim panel to door.
(4) Position retainer sleeves into door. Rotate
retainer sleeves 90° to secure into place.
(5) Install half door window.
HALF DOOR
REMOVAL
(1) Open the door.
(2) Disconnect the door restraint strap from the
pin (Fig. 35).
(3) Remove the nuts at the door hinge pivots and
lift the door from the body.
INSTALLATION
(1) Position the door in the hinge and install the
nuts.
(2) Connect the door restraint strap at the pin.
HALF DOOR HINGE
The service procedures for the half door hinge are
the same as the full door hinge. Refer to, Full Door
Hinge Removal/Installation procedures in this group.
Fig. 33 Window Regulator Bolts
Fig. 34 Regulator Removal
Fig. 35 Restraint Strap
23 - 28
BODY
TJ
REMOVAL AND INSTALLATION (Continued)