Jeep Wrangler 1997 Manual - page 1031
(a) Attach dial indicator (C-3339) to converter
housing. Position indicator plunger against input
shaft and zero indicator.
(b) Move input shaft in and out and record read-
ing. End play should be 0.56 - 2.31 mm (0.022 -
0.091 in.).
(44) Position transmission on work surface with
pan face upward.
(45) Install valve body.
(46) Adjust front and rear bands.
(47) Install fluid filter and pan.
(48) Install rear extension housing.
(49) Install torque converter.
OVERRUNNING CLUTCH/LOW-REVERSE DRUM
DISASSEMBLY
(1) If the clutch assembly came out with the low-
reverse drum, thread two clutch cam bolts into the
cam. Then lift the cam out of the drum with the bolts
(Fig. 111). Rotate the cam back and forth to ease
removal if necessary.
(2) Remove the clutch roller and spring assembly
from the overrunning clutch race.
Fig. 109 Installing Oil Pump And Reaction Shaft
Support
Fig. 110 Checking Input Shaft End Play
Fig. 111 Removing Overrunning Clutch From
Low-Reverse Drum
TJ
TRANSMISSION AND TRANSFER CASE
21 - 125
DISASSEMBLY AND ASSEMBLY (Continued)