Jeep Wrangler 1997 Manual - page 1029
(30) Insert front band into opening at front of
transmission case (Fig. 103).
(31) Install front and rear clutch units as assembly
(Fig. 104). Align rear clutch with front annulus gear
and install assembly in driving shell. Be sure out-
put shaft thrust washer and thrust plate are
not displaced during installation.
(32) Carefully work assembled clutches back and
forth to engage and seat rear clutch discs on front
annulus gear. Verify that front clutch drive lugs are
fully engaged in slots of driving shell after installa-
tion.
Fig. 100 Assembling Front And Rear Clutch Units
Fig. 101 Output Shaft Thrust Washer
Fig. 102 Aligning Rear Clutch Disc Lugs
Fig. 103 Front Band
Fig. 104 Installing Front/Rear Clutch
TJ
TRANSMISSION AND TRANSFER CASE
21 - 123
DISASSEMBLY AND ASSEMBLY (Continued)