Jeep Wrangler 1997 Manual - page 1014
(2) Remove adjusting screw bracket, line pressure
adjusting screw (Fig. 40).
(3) Remove switch valve and spring, pressure reg-
ulator valve and spring, kickdown valve and spring,
and throttle valve from valve body (Fig. 40).
(4) Secure detent ball and spring in housing with
Retainer Tool 6583 (Fig. 41).
(5) Remove manual shaft E-clip, washer, and seal
(Fig. 42).
(6) Pull manual shaft and park rod assembly
upward out of valve body and off throttle lever (Fig.
42).
(7) Remove manual valve from valve body (Fig. 43)
(8) Remove Retainer Tool 6583. Then remove and
retain detent ball and spring (Fig. 42).
(9) Remove throttle lever (Fig. 42).
(10) Remove park rod E-clip and separate rod from
manual lever (Fig. 44).
(11) Remove converter clutch solenoid from separa-
tor plate (Fig. 45). A T25 torx bit is required to
remove solenoid attaching screw.
(12) Remove screws attaching converter clutch
module to valve body and remove module and con-
necting tube (Fig. 46).
(13) Remove screws attaching end cover plate to
torque converter module (Fig. 47).
Fig. 39 Valve Body Assembly
Fig. 40 Adjusting Screw Bracket, Springs, Valve
Removal
Fig. 41 Securing Detent Ball And Spring With
Retainer Tool
Fig. 42 Manual And Throttle Levers
Fig. 43 Manual Valve
21 - 108
TRANSMISSION AND TRANSFER CASE
TJ
DISASSEMBLY AND ASSEMBLY (Continued)