Jeep Wrangler 1997 Manual - page 868
(2) Install the bolts that attach the side step to the
frame.
FULL DOOR TRIM PANEL
REMOVAL
(1) Lower the window.
(2) Remove the clip attaching the window glass
regulator handle to the regulator. Remove the han-
dle.
(3) Remove the screws attaching trim panel to
door (Fig. 18).
(4) Remove push-in fasteners attaching trim panel
to door with special tool C-4829.
(5) Lift the trim panel upward and separate the
trim panel from the door.
INSTALLATION
(1) Position the trim panel on the door.
(2) Press the push-in fasteners attaching trim
panel to door into place.
(3) Install the screws attaching trim panel to door.
(4) Position the clip on regulator handle and
install the handle on the regulator.
FULL DOOR
REMOVAL
(1) Open the door.
(2) Disconnect the door restraint strap from the
pin (Fig. 19).
(3) Remove the nuts at the door hinge pivots and
lift the door from the body.
INSTALLATION
(1) Position the door in the hinge and install the
nuts.
(2) Connect the door restraint strap at the pin.
FULL DOOR HINGE
REMOVAL
(1) Remove the door.
(2) Mark the outline of the existing hinge on the
body and the door with a wax pencil for installation
alignment reference.
(3) Remove the nut from the upper hinge pin (Fig.
20).
NOTE: When removing the door or hinge DO NOT
discard the plastic shims or the hinge pin.
(4) Remove the hinge-to-body screws and the
hinge-to-door screws. Remove the hinge from the
door and body. Support the door as necessary.
Fig. 17 Side Step
Fig. 18 Full Door Trim Panel
Fig. 19 Restraint Strap
23 - 22
BODY
TJ
REMOVAL AND INSTALLATION (Continued)